V2 Flat Face Trigger Shoe x 5

This is not my Design, all credit goes to Pembie. Please support him and buy something from his site at https://pembletonandsons.com/

These new flat face V2 trigger shoes allow the use of a slide release

The Trigger shoes are made of PLA+

Pack of 5

AR Bolt Catch Spring Version does not include an AR Bolt Catch Spring

Recommendations for best operation:

-Use a 22lb or higher recoil spring, you can also use an o-ring to increase spring tension on your stock recoil spring and sometimes that works also

-Use a 3.5lb trigger connector on your trigger housing

-Oil and lubricate your setup as much as possible so that there is close to zero friction and all moving parts slide and glide against each surface. There are dozens of good and highly detailed oiling and lubricating videos available on YouTube regarding your exact model

-Also oil/lubricate all moving parts in this kit that move and rotate such as your trigger bar, trigger shoe, and the reset

-You may have to file a slight bit where your barrel and the reset make contact for best results and smoothest operation

-If possible get a dremel and polish your barrel where it makes contact with the reset. I also recommend at that point since you already have the dremel and polishing paste/liquid out just polish your lower parts kit wherever there is contact made between parts, again there are dozens of videos on YouTube that go in depth regarding polishing and smoothing up your lower parts kit and slide where metal parts interact with each other, you will love the end result and have a nicer smoother cleaner trigger pull doing so. For rounds to cycle and feed properly also look into polishing your barrels feed ramp and the chamber, especially the roof of your chamber where the tip of your bullets touch when feeding.